motium MLC-1010, Руководство пользователя, Страница: 23 / 41

User Manual Rev 1.0 23
6. Care and Maintenance
The product requires little in the way of maintenance. Things to consider are:
•
The rear panel is used to dissipate heat that might otherwise build-up inside the
monitor. Keep the rear panel free of dust and dirt buildup, as this will reduce its
effectiveness. If there is a large amount of dust, this should be cleaned off, using
a firm-bristled brush (not a wire brush).
•
The touch screen, and enclosure should be cleaned with a soft, dry cloth.
•
Do not use harsh abrasive materials as this will scratch the surface.
•
A lint-free cloth with water or Isopropyl Alcohol can be used to clean the front
of the touch screen. Products designed to clean the front of LCD monitors
can also be used.
•
Persistent dirt can be removed using a damp soft cloth (use only a mild
detergent). If the unit is very dirty, it can be hosed down first. In this case, make
sure the mating connector is plugged into the connector on the monitor’s rear
panel (or keep water way from the connector).
6.1. Removable protective film
The monitor is supplied with a removable protective film fitted on top of the touch screen,
to protect its surface from damage. (The touch screen’s surface can be scratched when
operators have sand or metal filings on their fingers, or where there is a chance operators
will use sharp objects such as screwdrivers.)
The film needs to be replaced when its surface is damaged (scratched), and it becomes
difficult to read the monitor.
The film is placed approximately 1mm in from each edge of the plastic case. To remove
the film, lift one corner, using something made of soft-plastic (so there is no risk of
scratching the touch screen), and then peel the film off.
To fit the replacement film:
•
Confirm the touch screen’s surface is free of dust and fingerprints.
•
Remove the release liner (clear colour) from the rear of the film.
•
Starting at one corner, place the film on top of the touch screen, and slide your
finger along one side, so the film is aligned with the edge of the plastic case.
•
Move your finger along the center of the film, from one side of the monitor to the
other, so that the film is in contact with the touch screen’s surface.
•
Work from the center to the edges, making sure that no air is trapped between the
film and the touch screen. Any trapped air bubbles need to be pushed to the
edges, otherwise they will be a distraction.
•
Finally, remove the protective release liner (green colour) from the front of the
film.
Refer to Motium’s web site, or contact your local reseller, for ordering information.
Motium’s web site also includes a video showing how to replace the film.