motium MLC-1010, Руководство пользователя, Страница: 14 / 41

14 MLC-1010 T
UFF
V
IEW
LCD Monitor
3.4. Rear view
As seen in the drawing below, located on the rear panel are:
•
The Monitor Signal Connector. The pin assignments and connector mating
models are described in Chapter 4,
Connector pin assignments .
•
The connector on the back of the monitor has male pins, while the cable end
has female sockets. This is for safety, because the cable side carries power.
•
The male pins are recessed quite far into the connector, so they cannot be
accidentally damaged.
•
The connector is polarised, and protected from misalignment, so the pins
cannot be damaged during mating.
•
The cable-end can be straight or right angle.
•
75mm VESA Mount. The monitor can be attached to a standard VESA bracket.
•
We suggest using M4 screws with a 12mm thread length (maximum 14mm of
thread), assuming the mounting plate on the VESA bracket is 2mm thick.
•
Cable Clamp. This allows the Monitor Power and Signal Cable to be clamped to
the rear panel using one or two P-clips.
Alternatively, the cable can be secured to the mounting bracket.
Note
All six M4 threaded holes are blind, so there is no risk of water or dust penetrating
the unit.
Monitor Signal
Connector
Cable
Clamp
VESA
VESA
VESA
VESA
Figure 3. MLC-1010 rear view