Mosa RENTAL GE 50 KR-5, Руководство по эксплуатации и обслуживанию

Страница: 47 / 68

43
6. Operation
1 - Check the fuel level and refuel if necessary to allow a
complete regeneration process.
2 - Disconnect all connected loads and leave the main ma-
chine switch on (insertion lever upwards).
3 - Press and hold the manual regeneration button for at
least 3 sec. until the procedure starts.
Note:
◦
The coolant temperature must be above 60°C.
◦ When the regeneration process is finished, the sys
-
tem warns the operator.
You can stop the process at any time by pressing the Re-
generation Inhibit button or turning off the engine.
Regeneration inhibit button
WARNING
•
The regeneration inhibit command is active only during automatic regeneration.
If manual (forced or service) regeneration is required, the system ignores the inhibit command.
•
If the machine is used for a long time with the regeneration inhibited, the system activates the
forced regeneration process with consequent reduction of the engine power.
Be sure to reactivate the auto regeneration as soon as the conditions allow it.
•
The disable setting is cancelled after the machine stop.
When the automatic regeneration needs to be turned off, perform the procedures each time the
engine starts.
If there is a possible danger caused by automatic regenera-
tion, such as the presence of flammable materials or brush
-
es around the machine, regeneration can be temporarily
inhibited.
Automatic regeneration can also be stopped while it is run-
ning.
1 - Press and hold the regeneration inhibit button for at least
3 sec.
Note:
◦
Disabling is indicated by activation of the regenera-
tion inhibit lamp.
◦
Once the appropriate conditions have been restored,
press the regeneration inhibit button again to restore
the Automatic regeneration.
The regeneration inhibit lamp will switches to the
inactive state.
D5260510
D5260520