43
MORNINGSTAR
CORPORATION
4.3 DIN Rail Mounting
The Relay Driver will mount to standard 1-3/8” (35mm) DIN rail.
Figure
21.
Figure
22.
Step 1
The DIN rail location should be protected from direct sun, high
temperatures, corrosive fumes, and water. Do not install in a
confined area where battery gasses can accumulate.
Step 2
Place the Relay Driver over the DIN rail in the location where it
is to be mounted. Make sure there is sufficient room above and
below the Relay Driver for wire connections.
Step 3
The Relay Driver was designed for tool-less installation onto a
DIN rail. On the bottom of the Relay Driver, there are 3 hooks
that catch the upper lip of the DIN rail and one wide tab that
