Morgana DocuFold Mk2, Руководство оператора

Страница: 8 / 28

Page 8
PAPER
Manual & Fine Adjustment
The fold plate length can be adjusted manually. You may need to make this adjustment to
achieve the exact correct length of fold. Button (CC) will select the upper fold plate & button
(DD) the lower fold plate. To make a manual adjustment to the position of the upper fold plate,
press and hold the upper fold plate button (CC). The dimension of the upper fold plate will now
be displayed in the control panel.
Note: - The upper fold plate shows the dimension of the front edge of the paper to the first fold,
the lower fold plate shows the dimension from the first fold to the second fold.
By turning the select knob (V) whilst still pressing and holding the upper fold plate button (CC)
the fold length of the upper plate can be lengthened or shortened. Turning the select knob (V)
clockwise will lengthen the fold plate length and by turning anti-clockwise it will shorten the
fold plate length.
The digits before the decimal point shown in the display are in millimetres, each ‘click’ of the
select knob (V) represents increments of 0.1 of a millimetre.
To adjust the position of the lower fold plate, press & hold the lower fold plate button (DD) and
adjust the length as described above.
When you have adjusted the fold length dimension, move switch (W) up to the Run position.
The plates will then position themselves according to the fold lengths you have selected.
With switch (W) in the Run position the left hand side of the control panel will display the letter
‘U’ which indicates a user setting followed by a letter that indicated the fold type. For example
the letters ‘UL’ would indicate a User setting based on a Letter fold and the letters ‘UH’ would
indicate a User setting based on a Half fold.
To check the fold position after making a manual or fine adjustment, press the system switch
(T) and then press the feed switch (U) down. The machine will feed 3 check sheets and stop.
After checking the 3-rd sheet, if the fold position is correct, move the feed switch up to the off
position and then immediately down to the pulse position and the machine will start to operate.
If after checking and further plate positioning is required, repeat the above procedure.
The final fold plate and delivery stacker settings can be ‘stored’ for retrieval at a later date, see
‘To Store A Programme’.