Page 17
FOLDER
DocuFold Mk2
ROLLER ADJUSTMENT
The unique fold roller design of your Morgana Docufold will fold most paper stocks without the
need for adjustment. If you have a requirement to fold very delicate or thicker stock or re-
feeding to produce a cross-fold the fold roller gap can be easily adjusted as follows: -
1. Remove the roller assembly from the machine as described above.
2. Loosen the Cap Head Screw on the operators side of the roller that you wish to adjust (any
of the 3 outer rollers) using the 5 mm Bondus ‘L’ wrench pro vided & release the M8 lock
nut on the non-operators side with the 13 A/F spanner provided.
3. Insert the 4 mm hex ball driver into the socket screw at the end of the roller shaft and rotate
in the required direction to adjust the roller gap.
4. The graphics on the inside of the roller side plate show which way to turn the roller to adjust
the gap relative to the centre roller.
5. Re-tighten the half nuts & cap head screws to lock the roller into position.
6. Repeat procedure for each roller that you wish to adjust and then replace the roller assembly
into the machine.
7. Reset the roller tilt knob (AA) back to the zero central position and screw in the Clamping
knobs (Y).
Rotate Roller in this direction to increase Gap
(each graduation equals 0.1 mm of gap adjustment)
Section Through Roller Assembly
Rotate Roller in this direction to increase Gap
(each graduation equals 0.1 mm of gap adjustment)
Rotate Roller in this direction to increase Gap
(each graduation equals 0.1 mm of gap adjustment)
Centre Roller
3 Outer Rollers (Adjustable)
Содержание DocuFold Mk2
Страница 13: ...Page 13 FOLDER DocuFold Mk2...
Страница 28: ...NOTES Page 28 PAPER...