Morgana DigiFold Pro, Руководство оператора

Страница: 25 / 63

Page 25 SYSTEM
NOTES:-
If a crease position is adjusted, the fold will move with it.
If a fold position is adjusted, then only the fold will move.
Adjust a fold only if the fold appears to be giving an out of square result or
cracking appears.
The fold is probably too close to the centre of the crease and will be trying to
fold from one side of the crease to the opposite side of the crease (see below
for explanation).
Paper Type - 0, 1, 2 and 3, is a fold compensation for variations in
paper thickness, hardness and substrate.
Set By Position,
SET BY POSITION
IMPORTANT NOTES.
1. If the fold is too near, or on the center line of the crease; the fold will try to fold
diagonally across the crease profile and pull the fold out of square to the paper.
The best fold squareness is achieved when the fold is on the center line of the
crease, it should be to one side of the crease center line as shown below.
Thus for a crease setting of 100 for example, the fold should be set to a figure
slightly smaller or greater than 100.
2. When using all dimensions are from the leading edge of the paper
as shown in the example on page 26.
not
.
l
Paper type
‘0’
Paper type ‘1’ ‘2’ ‘3’
- The crease and fold are set at exactly the same position. This may
be used but beware some thin stocks will allow the fold to wander from one side of
the crease to the other.
and will move the fold relative to the crease and
should be tried out with the stock in use.
Generally a higher number will be best for a thicker stock, but some settings will
swap the fold from one side to the other side of the crease, this enables the user to
choose the side that the crease will be seen. For example, on a front cover.
l
center line of crease
ideal fold line
ideal fold line
DigiFold Pro
Operating the DigiFold Pro