8. Attention
A. Closing force should not be too much, it should be light and even, so as not to
damage the parts.
B. Do not allow nails, metal, hard rock mixed with abrasives to enter the mill.
C. It is strictly prohibited to idle the mill to the closed position thereby air grinding the
rollers, the hopper should be ready with a small amount of material and the gate opened
in a timely manner.
D. If the wear plate in the mill is damaged, you may order from your local distribution
department, or, you can buy directly from the company. Tel: 0531-61329851,
13066038695
E. This machine mainly is designed to crush malted material. When grinding corn, there
is a need for a coarse grinding roller; it can also be used to remove the germ and then
crush into a fine powder as a processing method.
F. This machine cannot not process soybean and high oil content material.
9. Common Malfunctions and Troubleshooting
Problem: Productivity is not up to the requirements.
Reason
Solutions
The flow is too small
Hopper adjustment mechanism above the
flow adjusting knob, appropriately increase
the flow.
Mill roll gap is not consistent
According to chart 1, adjust the handwheel till
the gap is consistent.
Big spring crushed
Adjusting lock nut outside of screw.
Two grinding roll diameter smaller, the size of
the gear scuffing
According to the roller use status, replace or
change the gear.
Low Speed
Adjust speed according to requirements.
