● Don't wear large or open clothes while operating the machine to avoid clothing
getting caught in the moving parts.
● Operators should inspect the unit and the operating area to ensure safety before
they start the mill.
● If the operator finds an abnormal circumstance, the operator should immediately
stop to inspect, it is strictly prohibited to eliminate the fault while the machine is
still connected to power.
● Do not put your hand into the gap of the grinding roller! When the feed mouth is
jammed, don't use the hands or sticks to help feed.
● The machine can be cleaned with tools like a brush to clean up. Make sure no
iron, stones and other debris are in the pulverizing material.
● Don't remove the cover on the side of the housing and the transmission wheel
when the mill is in operation!
● When repairing the equipment, only remove cover or when the machine is
stopped, after maintenance the cover shall immediately be re installed.
In order to highlight and facilitate more accurate understanding, the following "safety
regulations" will be in the form of graphic for further elaboration:
Special reminder
● Safety alert w safety precautions and safety signs that must be
followed, otherwise may cause personal injury or machine failure.
● Operating personnel must be trained, and obtain the certificate before operating.
● Before using the mill, the operator must read the instructions carefully,
understand and master the content, and strictly abide by the safety regulations.
● The safety mark must be kept clean, if the mark is damaged or lost, it must be
ordered and labeled once again.
● It is not allowed to convert the mill privately, or it may cause performance
degradation, mill damage or danger.
Garment Safety
● While operating the machine, the operator is not allowed to wear large or open clothes,
or the clothes might be caught by the mashine and cause injury.
● It is prohibited to wear a headscarf, scarves, neckties or wearing a tie towel at the waist.
● It is prohibited to wear open toed shoes.
Safety inspection and repair
● When this machine needs to be repaired by electric welding, it should be stopped
and the power should be cut off.
