adjusting mechanism of the adjusting plate according to the size of the final products.
Revolving the left and the right hand wheel while adjusting the flow control knob.
Adjusting the interval between the mill roller, and the smaller interval is adjusted, the
smaller size of final products you will get.
Notes: The left and the right hand wheel should be adjusted at the same time, and
they should have the same number of the circles, or the interval on both sides of
the mill roller will not be uniform.
You can fasten the locknut to enter the normal working state when the size of the final
products meets your requirements. In order to adjust the machine quickly, you can write
down the data for your reference.
Regarding 4 roller, 6 roller and 8 roller combination malt crushers, they have the same
adjustment method as the 2 rollers malt machine.
6.3 The adjustment of wallboard (Please check table 1)
Wooden or Nylon wallboard is installed on the inner wall of the crushing cavity on both
sides of the mill rollers, to prevent the raw material from leaking from both ends of the
rollers. When the diameter of the mill rollers becomes too small, you should loosen the
clamp nut of the wallboard, and move down the wallboard. You can fasten the clamp nut
if there is no raw material left in both ends of the rollers.
7. The maintenance, replacement and demounting of the mill
roller
The correct installation, maintenance and diagnosis of the mill rollers will increase the
performance and service life of the mill, it also can save cost and manpower at the
same time. After using the ginder for a period of time, you will need to maintain and
adjust the mill according to the following methods.
7.1 The teardown of the mill roller
mill roller removal and installation.
a. Remove protective cover, V-belt and V-pulley
b. Remove the small and big wheel gears
c. Remove the adjusting mechanism.
d. Open the bearing block and remove the mill rollers
Notice: You should check the steel wire rope which is used to
