K6862043
3/11/14
6
NOTE: When routing the body harness, make sure
the harness cannot contact any moving parts
or hot exhaust.
22. Route supplied body harness (A) from the back of
the vehicle to the front as shown, following the
existing harness on the driver side. Tie straps must
be used every 150mm to secure harness (A) to
the existing vehicle harness.
23. Remove the ground bolt (2) located on the left
fender next to the Power Distribution Center (PDC).
24. Connect the black wire in the supplied body harness
(A) to the ground location on the fender.
25. Install the ground nut (2). Tighten the ground bolt to
9 N·m (80 in. lbs.).
26. Release the PDC retaining clips (1) and remove the
PDC from the mounting bracket.
www.mopar.com
A
2
1
1
