7
B. Connect the harness 5-way female
connector to the vehicle’s ignition
switch.
C. Connect the harness 5-way male
connector to the vehicle’s 5-way
ignition connector previously
removed from the ignition switch.
D. Using a supplied 1/4” screw, secure
the black ground wire with ring
terminal to the metal under dash
brace as shown in diagram.
3.
Install Custom Harness.
A. Locate ignition switch connector,
directly behind the ignition switch.
Release the red secondary lock.
While pushing on main release,
remove connector from ignition
switch.
E. Run the harness White/Green wire
to the brake switch. Connect by
center-splice to the White/Green
wire in Cavity #2 of the grey 6-way
brake connector, following the
center-splice procedure above.
Secure wire to the factory wire
harness with a wire tie as shown.
Caution: Keep wire away from
the exposed steering column!
Caution: Do not remove the
brake lamp switch from the
mounting bracket. If the switch
is removed from the mounting
bracket, it MUST be replaced
with a new switch.
Center-Splice Procedure