6
Component Installation
1.
Install Hood Safety Switch.
A. Using (2) of the supplied 1/4”
screws, secure hood safety switch
on driver’s side rear corner of hood
per the diagram.
Note
: Wire exits
top of switch. Switch must be
bent at 45 degree angle.
B. Route the hood safety switch
wiring under the engine compart-
ment cover panel as shown in the
diagram.
C. Using a supplied 1/4” screw,
secure the ground lead from the
switch to the cowl as shown in the
diagram. The remaining wire will be
connected later.
D. Locate a visible area in the front of
the engine compartment to mount
the underhood warning sticker as
shown in the diagram.
2.
Install Dipole Antenna
A. Mount dipole antenna to the
windshield above the rearview mirror
and below the black windshield
trim.
B. Run the antenna wire above the
headliner to the driver’s A-pillar.
Temporarily remove the A-pillar
rubber gasket and run the antenna
lead down through the left side
dash opening. Replace the rubber
gasket. Ensure the antenna is
securely tucked above the head-
liner and is not visible along the
entire length.