Manual Part No: 930154-01
MD Electric Grill
- 9 –
Manual Rev No: 1
Installation (cont.)
Electric Connection
The connection should be made in electrical conduit, via fused mains isolator on the wall adjacent to the
appliance. The final connection
MUST
be in flexible conduit so that the connections can be made at the
rear of the appliance before it is moved into position.
ENSURE THAT THE CONDUIT IS CLEAR OF THE
FLOOR WHEN THE APPLIANCE IS IN POSITION
.
Summary of Installation Procedure
1) Check from the Data Plate that the appliance is suitable for the supply and note the loading for
each phase.
2) Fit and connect in conduit, a fused isolating switch on a wall convenient and within easy reach of
the
range.
3) Connect from the appliance to the isolating switch in conduit, fixed or flexible.
4) Move the appliance and its stand where appropriate, into its working position.
5) Ensure that any remaining packaging and protective covering is removed.
Checking the Operation
ALTHOUGH EVERY APPIANCE IS TESTED AND SET BEFORE IT LEAVES THE FACTORY, IT IS IMPORTANT
THAT THE INSTALLER RE-CHECKS CERTAIN FUNCTIONS BEFORE LEAVING THE SITE.
1) Ensure that the switch/es on the grill is/are in the "
OFF
" position(s).
2) Turn on the mains isolating switch and check that the green "mains On" light glows.
3) Turn on the 3 heat switch/es to position 1, leave for two to three minutes, sufficient to note that all
the elements are heating up. Turn to position 2, leave for a further two to three minutes and note
that one of the elements rises in temperature. Turn to position 3 and note that both elements are
full on.
Note
: If the appliance has been in store for a prolonged period, particularly if the storage conditions
have been moist, the grill should be "dried out" with the switch set at position 1, for one hour
before operating at full on.
WHEN THE INSTALLATION IS COMPLETE, LEAVE THE INSTRUCTION MANUAL WITH A RESPONSIBLE
MEMBER OF THE KITCHEN STAFF.
