Installation
Page 4
XG0675 - 151207
System Check
•
Slide the 3-position button on the remote receiver to the ON position. The fireplace will go through the start cycle
and the hot surface igniter will glow after the pre purge time and ignite the pilot. NOTE: If the remote does not
communicate with the reciever, go to the section: Learning Transmitter to Receiver.
After the pilot flame is lit, the main gas valve should open and the main gas flame should ignite.
•
Slide the button to OFF. The main gas flame and pilot flame should both extinguish.
The power vent will turn off after 3 minutes post purge.
•
Slide the button to REMOTE, then press the ON button on the transmitter to change the system to on.
Learning Remote to Receiver
This transmitter has one of 65,536 unique security codes. It may be necessary to program the remote receiver to
“learn” the security code of the transmitter upon initial use, if batteries are replaced, or if using a replacement transmit
-
ter.
NOTE:
This receiver can hold up to 3 transmitter codes. This is for the times when a second hand held transmitter or
a wall transmitter is required.
•
Make sure the receiver’s slide switch is in the REMOTE position.
•
Press and release the LEARN button on the receiver.
•
When you hear the “Beep”, press and hold the ON or OFF button for about 2 seconds on the transmitter.
•
You will then hear a series of rapid beeps that indicate that your new transmitter has been accepted by the re
-
ceiver.
•
If you press the LEARN button on the receiver and you hear no beeps, the receiver is unable to retain any more
transmitter codes
(make sure the transmitter battery is properly installed and fully charged).
•
To delete all of the transmitter codes on your receiver, press and hold the LEARN button for 10 seconds. Then
you will hear a series of three long beeps, indicating that the receiver’s memory has been cleared.
Remote Wall Clip
The remote can be mounted on a wall using the remote
wall clip included.
•
Wood - Drill 1/8’’ pilot holes and install with screws
provided.
•
Plaster/Wallboard - Drill 1/4’’ holes, then install with
the screws provided.
Figure 7.
Installing Wall Clip
Содержание RXM5010
Страница 8: ...XG0675 151207 RXM5010 Touchscreen Remote ...