Page 7 of 13
MW38-BV Modular Fireplace
XG0310 Rev. 01 - 11/98
Removing and Installing
the Door
Removing the door surround:
The door surround is held in place by two metal clips at the top, and
one magnet on each side. To remove the surround, pull the bottom
outwards and lift upwards until the slots "A" are clear of tabs "B" in
the door. You may need to use a flat screwdriver to pull the door
surround outwards.
(See figure 11a).
Installation
Removing and Installing
the Insert
You may
remove the insert
to protect it from theft and damage
during construction.
1.
Remove the two machine screws (1 left & 1 right) at the top of the
insert that attach the insert to the shell.
See figure 10, inset 1.
2.
Remove the 4 machine screws that hold the venting plate to the
insert. For easier access, you may remove the effiiciency baffles
to gain access to the venting plate.
3
. Remove the insert by tipping the top of the insert outward and
lifting the tabs past the slots in the bottom of the shell.
See figure
10, inset 2.
Store the screws and clamps in a safe place to ensure that they are
not lost.
To
re-install the insert
simply reverse the steps above.
Remember
to re-install the efficiency baffles if they were removed.
Removing the door:
Remove the machine screws along the top of the door, and then pull
the door outwards and upwards until it is clear of the door rail.
(See
figure 11b).
Ensure that a good seal is maintained when installing the
door.
Figure 10.
MW38-BV insert.
INSET 1
Tab
INSET 2
Mounting
Bracket
Figure 11a.
Removing or installing the door surround.
Glass door
and frame
Door surround
Tab 'B'
Slot 'A'
Magnet
Pull bottom of door
surround outwards
and upwards.
Glass door
& frame
Figure 11b.
Removing or installing the glass door.
Venting Plate
Front
Slot
