Page 18
HW-Series Gas Fireplace
Part No. XG0190 - 071409
Operation - Model HW38DF-I
For Your Safety - READ BEFORE LIGHTING:
To Turn Off Gas To Appliance:
Lighting Instructions:
■
If you cannot reach your gas supplier, call the Fire
Department.
C.
Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service technician.
Force or attempt to repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system,
and any gas control which has been under water.
A.
This appliance is equipped with an ignition system that
lights the pilot burner automatically.
Do not attempt to
light the pilot by hand.
B. BEFORE LIGHTING
smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
■
Do not try to light any appliance.
■
Do not touch any electrical switch; do not use any
phone in your building.
■
Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
1.
Turn off remote switch.
2.
Flip down the lower trim.
3.
Turn the switch on the gas control to "Off".
4.
Flip up the trim.
1.
STOP!
Read the safety information above on this label.
2.
Flip down the lower trims.
3.
Turn switch on the gas control to OFF".
4.
Wait 5 minutes to clear out any gas. If you smell gas,
STOP!
Follow "B" in the safety information above on this
label. If you don't smell gas, go to the next step.
5.
Turn switch on the gas control to "ON".
NOTE:
This unit is
equipped with an ignition system that lights the pilot burner
automatically.
Do not attempt to light the pilot by hand.
6.
Turn on wall switch.
7.
Flip up the lower trim.
8.
If the fireplace does not operate, follow the instructions "To
Turn Off Gas To Appliance" and call your service technician
or gas supplier.
with Honeywell Electronic Ignition
Gas
Inlet
Gas Control Switch
Shown in "On" Position
WARNING:
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
