B-Series DV-2 Gas Fireplace
Page 20
Part No. XG0160 -151125
Installation
Installing the Log Set
Single Cast Log Set
Installing the Logs:
Unpack the log set and handle very carefully.
1.
Remove the door cover and the glass door.
2.
Place the single cast log. Set firmly in place as shown below.
3.
Place the Front log onto the front log rest as shown in figure
30. Center the log from side to side, and push it against the
back of the log rest. Carefully push the log onto the metal
spikes on the log rest.
4.
Place the top logs in position as shown in figure 30a, place the
centre log down first, then the right and left logs.
5.
Start the fireplace. If the flame appears satisfactory, replace
the glass door and door cover.
Figure 30.
Positioning for the single cast log set.
Figure 30a.
Proper log placement.
single cast log set
CAUTIONS:
•
If logs are not placed properly, excessive sooting will
result.
•
The surface of the logs will crack due to the heat of
the flames. This is a normal occurrence.
Figure 30b.
Proper log placement.
