24
Place glass onto the fitter by thread-
ing the light kit pull chain through
the glass, rubber washer, hex nut,
finial cap, and finial. Tighten the
finial securely by hand.
Connect the plug from motor to the
plug from the switch cap.
29
Remove the hex nut and lockwasher
from the switch cap.
26
Disconnect the two plugs in the
switch cap. White wire from the
white wire, the black wire from the
blue wire.
25
Remove the switch cap from the fit-
ter.
27
Connect plug from motor to the plug
from the switch cap.
21
Install switch cap with fitter onto fan
using 3 screws removed from step
17 and tighten securely.
22
Install 2x60 watt candelabra bulbs. Bulbs
included.
WaRnInG: over lamping
the fan will result in the fan
lights shutting down until the
proper wattage of bulbs are
installed. Reset the lights by turn-
ing off the wall switch, breaker,or by
remote. Replace bulbs with the cor-
rect
wattage bulbs, turn the power
on.
23
Remove the finial, finial cap, hex
nut, and rubber washer from the fit-
ter.
20
For fan with
light kit go to
step20.
For fan without
light kit go to
step 25.
Remove the double sided sticky tape
and stick the capacitor to the switch
cap plate.
19
Insert the center plastic plug provid-
ed into the center hole of the switch
cap.
28
