24
Remove finial nut, hex nut, and finial
cap from the fitter.
23
25
Install 3 x 40 watt candelabra bulbs.
Bulbs are included.
WaRnInG:
Over lamping the fan will
result in the fan lights shutting down
until the proper wattage of bulbs are
installed.
Reset the lights by turning off the wall
switch, breaker,or by remote. Replace
bulbs with the correct wattage bulbs, turn
the power on.
Place glass, finial cap, hex nut, and
finial onto the fitter securely.
Disconnect white wire from fan and
white wire from fitter. Disconnect blue
wire from fan and black wire from fit-
ter.
26
Install the 3 screws previously
removed from step 18.
22
For fan without light kit
go to step 26-31 to
finish.
For fan with light kit go
to step 21-25.
Connect plug from fan to plug from
switch cap..
21
Remove the double sided sticky tape
and stick the capacitor to the switch
cap plate. Receiver needs to be stuck
to the switch cap plate also by using
2 double sided sticky tapes included.
20
Remove the switch cap from the fit-
ter.
28
Remove the hex nut and lock washer
from the switch cap.
27
Insert the center plastic plug provid-
ed into the center hole of the switch
cap.
29
Set dip switches on the Remote Transmitter
and Remote Receiver to the same settings.
This must be done so the units will com-
muncate properly. If you have other fans you
can set to control from one transmitter by set-
ting both receivers the same as the transmitter.
If you have more than one fan with remote.
You can set the dip switches to different posi-
tiosns to have seperate control.
Remote
Transmitter
Dip swtiches
Remote Receiver Dip switches
19
Set remote receiver located
down inside of fan switch
cap.
