Montag C06B, Руководство по эксплуатации, Страница: 31 / 33

31
7.3 KNUCKLE HITCHES
Crushing hazard.
The hitch may have a negative draft load (upward force).
Before disconnecting from tractor:
• Park the equipment on firm, level surface.
• Place tractor transmission in park, turn tractor engine off and remove ignition key.
• Block the wheels.
• Verify service locks are properly engaged or lower tool bar and lower row units to
the ground or pavement.
• Remove all product from tank.
1. Remove lock nuts, washers and bolts (A).
2. Remove knuckle universal joint (B).
3. Remove universal joint, bolts, washers and lock nuts.
4. Remove old bushings (C).
Note: To avoid damaging bushing, install with a non-marring
implement, such as a rubber mallet, or with a block of wood to
protect bushing during installation.
5. Install new bushing with a non-marring implement until
outer end of bushing is flush with pin sleeve.
6. Reassemble universal joint.
7. Torque nuts (D) to 700 ft. lbs. (949 Nm) or use thread locker.
8. Lubricate universal joint with a recommended grease.
9. Tighten nut until it makes full contact with plate. Do not overtighten as this can damage parts.