CONTROLS AND CONNECTIONS
Front Panel
Power Switch:
In normal operation, use this push button to power the amplifier on and
off. When the switch is pushed in, power is on. Note that the amplifier can also
be powered on from standby using a 12VDC external trigger or automatically
when an audio signal is detected on one of the inputs, depending on the setting
of the
Power Control
switch on the rear panel.
Speakers (A and B):
Use these push buttons to select which of the two speaker zones
is active. When the button is pushed in, the speaker zone is enabled. When the
button is out, the speaker zone is off. In normal operation, you may use either or
both zones at the same time.
Power Indicator:
When there is no power applied to the amplifier, this indicator is off.
When the amplifier is powered on and active, the indicator glows blue. When the
amplifier is powered on, but is in standby more, the indicator glows red.
Balance:
Use this knob to fine tune or temporarily adjust the balance between the left
and right channels. This knob should only be used to temporarily adjust balance.
The primary balance should be set using the
Master Volume
controls on the rear
panel.
Volume:
Use this knob to adjust decrease the maximum volume level set using the
Master Volume
controls on the rear panel.
Rear Panel
Primary Line:
This stereo RCA input is intended for an input that will be normally off or
inactive. Whenever a signal measuring 5mV or more is detected on the inputs,
the amplifier will automatically switch to this input.
Speaker Level Input:
If one of your inputs is a speaker level output from another
amplifier, such as in a whole home entertainment system, you can use these
push button speaker grip connectors to connect the speaker wires from the
source. These connectors can accept 20-24 AWG speaker wire.
Primary Line/Secondary Line:
This switch determines whether the
Speaker Level
input will be considered the Primary Line or Secondary Line input. If both Line
Level and Speaker Level inputs are on the same Line (Primary or Secondary),
the Line Level input will override the
Speaker Level
input.
Содержание PID 11497
Страница 1: ......
