Monoprice PID 11497, Руководство пользователя

Страница: 6 / 11

AWG inserted into the holes on the post, bare speaker wire wrapped around the
post, spade plugs, pin plugs, or banana plugs. In normal operation you can have
two sets of stereo speakers operating at the same time. However, in Bridged
mode, you can only use speaker bank A with a single speaker connected to the
positive (+) terminals, as indicated on the rear panel.
Power Connector and Fuse Holder: Plug the included AC power cord, or an exact
replacement, into this C14 panel connector. The panel connector also contains
the fuse behind a small door. If the fuse requires replacement, replace with the
type listed in the
Specifications section.
Voltage Select Switch (120V/230V): Use this switch to set the input to 115/120V or
230/240V. Double check the position of this switch before plugging the amplifier
into an AC power outlet. When switching voltage, you must ensure that the fuse
is the correct type for the voltage level in use. See the
Specifications section for
the fuse types to use with each voltage value selected.
CABLE PREPARATION
You will need several types of cables for this installation, the specifics of which vary
depending on your installation choices. None of the cables or connectors mentioned in
this section are included with the system.
Important Safety Note! If you plan on running any of these cables through the walls,
through a connecting floor, or inside an air duct, they should be rated for In-Wall, Riser
(between floors), or Plenum (air duct) use, respectively. Using unrated or improperly
rated cables could accelerate the spread of any fire and could nullify insurance claims.
Speaker Wires
You will need speaker wire to connect each speaker to the amplifier and to connect one
of the sources, if necessary. The size (AWG) of wire you choose depends on the
distance from the amplifier to the speaker(s), the speaker impedance, and the physical
limits of the terminals at each end.
Other than saving a few pennies of cost or grams of weight per foot, there is no reason
to use anything other than the thickest wire possible. This amplifier can accept up to 7
AWG wire, so it is recommended to use 10 or 12 AWG speaker wire. If the speaker