24. With the audio material playing, turn the
Volume
knob on the front panel to the
Max position.
25. Using a small screwdriver, slowly increase the left channel
Master Volume
control on the rear panel until the volume is at your desired maximum level. Do
the same for the right channel
Master Volume
control.
26. Check the balance between the two channels and adjust the
Master Volume
controls as necessary to obtain the desired balance.
27. Use the
Volume
control on the front panel to set the volume level to a
comfortable listening level and use the
Balance
control on the front panel to
make minor, temporary adjustments to the audio balance.
28. Start playing audio material on your Primary source. The amplifier should switch
over to the audio from the Primary source.
29. Stop playback from the Primary source. Note the length of silence before the
amplifier switches back to your Secondary source. This amount is determined
by the
Delay
control on the rear panel and can be between 3 and 15 seconds.
30. Using a small screwdriver, adjust the
Delay
up or down as desired. Note that if
the delay is too short, a pause while a CD changer changes discs, for example,
could cause the amplifier to switch sources.
31. If you want the amplifier to power on and off with a trigger signal, set the
Power
Source
switch to the
Trigger
position. If you want it to turn on when audio
source material is detected and turn off when there is no longer an audio
source, set the
Power Control
switch to the
Auto-on
position. Otherwise, leave
the
Power Control
switch in the
Normal
position.
Congratulations! Your amplifier is now properly setup and ready for use!
Содержание PID 11497
Страница 1: ......
