Connecting the Triggers
14. If you will be using a trigger to turn the amplifier on and off, plug a 3.5mm TS or
TRS cable into the
12V Trigger In
jack and the other end to the trigger output of
another device. Set the
Power Control
switch to the
Trigger
position.
15. If you want to trigger another device whenever the amplifier is powered on or off,
connect a 3.5mm TS or TRS cable to the
12V Trigger Out
jack and the other
end to the trigger input of the device you want to activate.
Connecting Power
16. Check the position of the
Voltage Select
switch to ensure that it is set to the
proper value for the AC power source.
17. This amplifier ships with an installed fuse that is appropriate for 110-120V AC
power sources. If you will be using this amplifier with a 220-240V AC power
source, you must change to the fuse to the type listed in the
Specifications
section for 230V sources.
18. Plug one end of the AC power cord into the Power Connector on the amplifier's
rear panel. Plug the other end into an AC power socket.
Setting the Master Volume and Delay
19. Temporarily set the
Power Control
switch to the
Normal
position.
20. Using a small screwdriver, set the
Master Volume
controls on the rear panel to
the minimum value.
21. On the front panel, set the
Volume
level to Min and set the
Balance
control the
middle (12 o'clock) position.
22. Depress the
Speaker A
button on the front panel. If you are using a second
speaker zone, depress the
Speaker B
button, as well.
23. Press the
Power
switch on the front panel to apply power. Power on your
Secondary source and cue up audio material that will be representational of the
maximum volume level you will want out of this amplifier.
Содержание PID 11497
Страница 1: ......
