Monark 928 G2, Руководство пользователя

Страница: 10 / 32

Unit
KM/H KM
ML/
MIN/ KG
KG
ConStAnt
1.00
CAdEnCE
60
Id00
bASE
25
WATT
St-StAtE
3
HR
+2 +4 +6 +10 -2 -4 -6 -10 RF
(rpm)
+
10
Monark 928 G3 / 928 G3r
Units
Kg, km, km / h, ml / min / kg are default. You can
switch between the different unit combinations with
(+/-) button.
Kg, km, km / h, ml / min / kg (default) •
Kg, km, km / h, METS •
Lbs, miles, miles / h, ml / min / kg •
Lbs, miles, miles / h, METS •
User settings
BikeID
This ID is a parameter that the PC software can
ask for. It is used to identify or number bikes when
multiple bikes are controlled by same PC or similar.
Set units
Set cycle
constant
Set metronome
cadence
Set cycle-ID
Set base
power
928 G3
Set steady
State HR
928 G3
928 G3:
The display returns
to start view
green
(reference)
or
ange
red
yellow
or
ange
red
yellow
or
ange
or
ange
Fig: Metronome
Here you can make individual adjustments to
optimize the bike for your needs on first use and when
needed.
Cycle constant
The cycle constant is as default set to 1.00. Change
using the (+/-) button.
When the cycle constant is set to 1.00 the power is
measured at the flywheel. This is used in Astrand test,
YMCA etc.
When the cycle constant is set to 1.05 the power
is measured at the crank. This is often used on
electronically-braked bikes.
Metronome cadence
Metronome diodes show pedalling revolutions (rpm)
relative to the set reference value. The metronome is
located at the back of the meter. The default value is 60
and can be adjusted with (+/-) button. The green LED
in the middle flashes twice for each pedal revolution
which helps to keep the right pedal cadence, see
Fig:
Display and Fig: Metronome .
The meter can be rotated so that the rider does not
see the values in the display, but only sees the flashing
diodes (in order to keep the right pedal cadence).
If START STOP is pressed, or if no
button is pressed for 20 seconds (in
all steps), the changes are saved and
the display returns to normal with
the new settings active.
928 G3r:
The display returns
to start view.
Press PLUS and PROGRAM
for 5 seconds to
set ‘User settings’.