Monark 891 E Wingate Option, Руководство пользователя

Страница: 11 / 24

1
2
3
4
5
6
7
Monark 891 E/891 E Wingate Option
11
Check at first that the brake belt is lying correct on
the flywheel brake surface. See
Fig: Brake cord
and
Fig: Brake device If the weight basket is in its upper
position, press the release button. The basket will fall
down and increase the tension of the brake belt/cord
against the flywheel.
Put 9 kg in the weight basket(5). See Fig: Brake device.
Rotate the flywheel by hand. The basket shall now lift
up so the distance to the flywheel is at least 40 mm
/1.6" and maximum 60 mm / 2.4". If this is not the
case the brake belt has to be loosened or tightened
a little at the tension centre (3). Lock tension centre
again, in its upper locking position, with the stop (1)
and then release the lock brace (2) for the brake line so
that its length can be adjusted. If the basket is too low,
shorten the belt somewhat. If the basket is too high,
lengthen the cord somewhat. Tighten the bracket again
and release and check if the measurements above are
OK when the flywheel is rotated by hand.
Fig: Brake cord
NOTE!
To receive correct workload it is important to place the
weight basket according to the description above. If
the basket hangs too low it may touch the flywheel. If
the basket is too high, wrong workload may obtains.
Fig: Brake device
1) Stop
2) Cord bracket
3) Tension center
4) Return strap
5) Weight basket
6) DC connector
7) Data output
Adjustment brake cord tension 891 E Wingate Option