19
CAUTION: Use of rechargers other than the one supplied (PSC-2U
for the DBL and PSC-PBXU for the PBL) will damage the
stroboscope and void the warranty.
When the recharger plug is inserted into the recharger jack, the strobe will
go into the Charging Mode. Make sure the trigger switch is not depressed.
The DBL strobe will not do anything else when charging (e.g. it will not
flash and the buttons have no function).
When charging, the strobe will indicate
CHRGE
in the bottom of the display.
The recharger will fast charge the batteries for about 4-5 hours and then
trickle charge the batteries.
Allow the recharger to charge the batteries until the display shows
DONE
for peak battery life performance. If the batteries are not charged to 100%
regularly, the batteries will lose capacity.
7.3 External Power Supply/Charger (PBL only)
The PBL will run continuously from the external power supply/charger
(PSC-PBXU) powered by the AC mains (115 – 230 Vac).
To run the PBL from the external power supply/charger (PSC-PBXU):
1. Plug the recharger cable into the recharger socket (located below
the display panel behind the handle).
2. Plug the recharger into an AC mains wall outlet (115/230 Vac).
3. Press the trigger switch to operate as normal. If the trigger switch is
not pressed, the strobe will start charging. The batteries ARE NOT
charged while the strobe is operational and running off the power
supply/charger.