8
6. Once the desired memory location is displayed, press the
MEMORY
button to store the current flash rate in that location. Press any
other button to cancel.
7.
DONE
will be displayed.
Internal Phase Delay
Once the flash rate has been adjusted to give a stopped motion image,
the PHASE DELAY button may be used with the knob to increase or
decrease the phase of the reference mark location. Use the PHASE
DELAY button and knob to bring a reference mark, such as a key way,
into your line of sight.
To adjust the Phase Delay:
1. Press the
PHASE DELAY
b
utton.
2.
PHASE
will be displayed on the bottom line and the current flash
rate will be displayed on the top line.
3. Turn the tuning knob to adjust the location (phase) of the reference
mark.
4. Press the
PHASE DELAY
button again to turn the Phase Delay
mode off.
4.2 Internal Mode - TACH Frequency Generator
In the Internal Mode, the strobe can be used as a frequency generator
(outputting TTL pulses) without having the strobe flash.
The pulse
output will still occur at the flash rate; the strobe is just not flashing.
To stop flashing:
Press the
ALT FUNCTION
button and then the
TACH
button. The TACH
icon will be displayed.
To start flashing again:
Press the
ALT FUNCTION
button and then the
TACH
button. The TACH
icon will go away and the strobe will start flashing again.
