MONARCH INSTRUMENT F2A1X, Инструкция по эксплуатации

Страница: 13 / 16

10
7.0 APPENDIX A - SERIAL PROGRAMMING COMMANDS
Programming the unit requires the optional USB Programming Cable with
associated PM Remote software and a PC running Windows XP or later
with an available USB port.
All serial commands are @ then two or more characters or words
separated by a delimiter “/”. One or two numbers follow some commands.
All valid commands respond immediately with an “OK” or data, or “ERR”
if incorrect. Default Baud rate is 9600. Communication requires the User
Programming Cable.
@PI Product Information, shows name \n Firmware revision \n
@C1 Shows all settings
@C2 Shows all settings with CR after each parameter
@D0 Sends current display value once
@D1 Sends display data continuously (at up to display update rate)
@D2 Stops sending data
@MX Sends Max reading
@MN Sends Min. reading
@RE 32 Resets Max
@RE 64 Resets Min.
@RE 96 Resets Max and Min.
@CH_A/TYPE Shows current type
@CH_A/TYPE = RPM Sets scale to 60 so displays in RPM
@CH_A/TYPE = FREQ Sets scale to 1 so displays in hertz
@CH_A/TYPE = SCALE Scale mode. Enter Scale factor.
@CH_A/TYPE/SCALE = 30.00 This will set the SCALE factor to 30.00
@CH_A/INPUT Shows Sense of trigger input
@CH_A/INPUT = POS (or NEG) Sets the sense of the input trigger
@CH_A/LOEND Sets how lo ng (in secs) with no pulses
before the unit outputs 0