MONARCH INSTRUMENT ACT-1B Series, Инструкция по эксплуатации

Страница: 5 / 16

2
2.1 Installation
Remove the mounting clips (if fitted) and install the unit into the panel
from the front. From the rear of the unit, install the mounting clips
on each side and tighten the mounting screws against the rear of the
panel.
WARNING: Do not over tighten the mounting screws.
2.2 Power
Power to the unit is connected to the terminals under the section
labeled POWER on the rear panel. Be sure the power supplied matches
the specification indicated on the rear panel. Refer to Figure 2 below.
If the unit is AC powered (100-240 V ac), connect the live (hot) wire
to the terminal marked L+ and Neutral (Return) wire to the terminal
marked N- .
If the unit is DC powered , connect the DC supply Positive to the
terminal marked L+ and the DC supply Negative or Common to the
terminal marked N- .
Figure 2 ACT-1B Rear Panel
USB
Programming
Jack