10
W
ATER
Sy
STEMS
- 6
2013 HOLIDAY RAMBLER
Gravity Fill
The gravity fill inlet allows fluids to be added
directly into the fresh water tank. Use only
potable water sources, solutions and delivery
systems when using the gravity fill inlet. Water
can also be poured directly from a container
into the fresh water tank. The gravity fill inlet
can be used to pour disinfecting solution into
the fresh water tank.
Connect a potable water hose from a
city water source.
Leave the water pump off.
Turn on the city water supply.
Monitor the tank filling process at all
times using the monitor panel.
When the fresh water tank is ¾ full,
prepare to shut the water supply off
when water begins to overflow from
the gravity fill port.
CAUTION:
Do not leave the
hose unattended
when filling
the fresh water
tank. Damage
to the plumbing
system, fresh
water tank or
flooding may
occur.
Water pump
The water pump pressurizes the fresh water
system when the recreational vehicle is not
connected to city water. The water pump is
automatic and self-priming, operating on
demand as water is used. Clean the inlet screen
about every two months or when flow of water
is reduced.
WARNING
Before leaving the recreational vehicle
for an extended period of time (i.e.
overnight or longer), be sure that the
city water and water pump have been
turned off. Damage from neglect will
be the responsibility of the owner, not
the manufacturer.
The water pump is operated by the water
pump switch located on the monitor panel. Do
not allow the pump to run with an empty fresh
water supply tank. Operation of the pump
without water may damage the water pump.
CAUTION:
Do not continue water pump operation
when the fresh water holding tank is
empty. Damage to the water pump
may result.
To operate the pump:
Fill the fresh water tank.
Turn on the water pump
from the monitor panel.
Open faucet valves to
purge system of air.
Close each faucet when it
delivers a steady stream of
water.
It will take several gallons
to fill the water heater
tank.
Water Pump Troubleshooting
Vibration induced by road conditions can
cause the plumbing or pump hardware to
loosen. Check the water pump system for
components that are loose. Many symptoms
can be resolved by tightening the hardware.
Check the following items:
Water pump will not start or blows the
fuse:
Check the electrical connections, fuse
or breaker, main switch and ground
connection.
Is voltage present at the pressure switch
on the pump? If voltage is present, the
pressure switch may be faulty. As a
test, temporarily bypass the pressure
switch.
Check the charging system for correct
voltage and good ground.
Check for an open or grounded circuit
or motor.
Check for a seized or locked diaphragm
assembly (water frozen).
Water pump inlet
screen: Located on
water pump. Clean
every two months.
040586
040483h
Gravity Fill Inlet
040433i
Water pump
040487x
Содержание HOLIDAY RAMBLER 2013
