Molnar SL02, Установка, эксплуатация и обслуживание, Страница: 9 / 22

Page 9 of 22 Rev B
–
Dec 2009
OPERATING INSTRUCTIONS
1. Drive vehicle on forward to front wheels rest
on stops
2. Place the four rubber pads under edge of
vehicle at the four jack points.
3. Press up button and raise vehicle to
required height. Do not go under vehicle
until load rests on safety.
4. When vehicle reaches maximum height
a limit switch will come into operation
and stop hoist. When hoist has
stopped, press down button until load
rests on safety mechanism.
5. While lifting the vehicle a clacking
sound should be noticeable which
indicates the safety mechanism is
operating. If this sound is not heard,
immediately cease using the hoist and
call an authorised service agent.
6. The following steps are to be taken
when lowering the hoist. Press the down
button twice within 2 seconds and continue
to hold, the hoist will raise up automatically
for 2 seconds. Safety will disengage then
hoist will begin to lower.
7. If vehicle is to be worked on at an intermediate
position, release down button. Allow
2 seconds then press down button once
to reapply safety mechanism.
9. To lower to ground level, repeat step 6
10. WARNING. Do not go under vehicle
under any circumstances while vehicle
is being raised or lowered.
11. WARNING. Load must be evenly distributed between both lifting platforms
If load is unbalanced reposition vehicle. DO NOT lower on to locks at different
heights.