Mohawk TR-110, Руководство пользователя

Страница: 8 / 76

MOHAWK MODEL TR-110 & TR-120
8
GENERAL INFORMATION CONTINUED
RECOMMENDED TOOL LIST
SIZE / QTY TOOL USED FOR
3/4 IN WRENCH / SOCKET HYDRAULIC HOSES
11 / 16 IN WRENCH / SOCKET HYDRAULIC FITTINGS
5 / 8 IN WRENCH / SOCKET HYDRAULIC FITTINGS
1-1/16 IN WRENCH / SOCKET RAMP / CROSSRAIL
1-1/8 IN WRENCH / SOCKET RAMP / CROSSRAIL / WEJ-IT ANCHORS
1-1/4 IN WRENCH / SOCKET CHAIN CONNECTORS
1 SET ALLEN WRENCHES AS REQUIRED
1 PLIERS / NEEDLE NOSE CHAIN MASTER LINKS
1 RATCHET AS REQUIRED
50 FT MEASURING TAPE SITE LAYOUT
1 CHALK LINE SITE LAYOUT ( BLUE / YELLOW CHALK )
4 FT BUBBLE LEVEL VERIFY LEVEL ASSEMBLY
25 FT FISH TAPE PULLING CHAINS
1 HAMMER AS REQUIRED
8 FT STEP LADDER ASSEMBLE ELEVATED ITEMS
4 4 X 4 X 24 IN DUNNAGE SUPPORT TRACKS OFF FLOOR
1 PRY BAR ADJUST HEAVY ITEMS
50 / 100 FT LEAD CORD OPERATE ELECTRICAL TOOLS
3/4 IN MASONRY DRILL BIT DRILL ANCHOR HOLES
1 IMPACT DRILL DRILL ANCHOR HOLES
2 FORK TRUCK (8000 LBS. MIN CAP.) ERECT / MOVE HEAVY COMPONENTS
WARNING
BEFORE DRILLING THE MOUNTING HOLES
x
AFTER VERIFYING THAT THE UNIT IS
OPERATING SMOOTHLY AND ALL POSTS ARE
SQUARE AND PLUMB, THE UNIT CAN BE
SECURELY MOUNTED TO THE SHOP FLOOR.
DO NOT ANCHOR INDIVIDUAL POSTS TO
FLOOR PRIOR TO ASSEMBLY OF LIFT OR
OPERATION!
x
REFERENCE ANCHOR BOLT INSTALLATION
SPECS FOR DRILLING AND AND INSTALLING
ANCHORS. OBEY ALL WARNINGS.
x
ENSURE THAT ALL POSTS ARE SHIMMED
PROPERLY. CHECK THE DIMENSIONS OF THE
POST AT THE BOTTOM FROM THE FACE OF
POST ONE TO THE FACE OF POST NUMBER
TWO.
x
CHECK THE DIMENSIONS OF THE POST AT THE
BOTTOM FROM THE FACE OF POST THREE TO
THE FACE OF POST NUMBER FOUR
x
USING THE HOLES AT THE BASE OF EACH
POST AS A GUIDE, DRILL THE FOUR
MOUNTING HOLES FOR THE ANCHORS. USE A
SHARP DRILL BIT AS NOT TO DRILL AN
UNDERSIZED HOLE. DRILL THE HOLE EQUAL
TO THE LENGTH OF THE WEJ-IT ANCHOR..
BLOW OUT THE HOLE WITH SHOP AIR, OR
VACUUM. INSERT THE ANCHOR SO THAT THE
WASHER RESTS AGAINST THE POST FOOTING.
WHEN THE LEVEL HAS BEEN VERIFIED,
TIGHTEN THE NUT THREE TO FIVE FULL
TURNS. ( 165-175 FOOT POUNDS )
x
MAKE SURE THE CONCRETE IS SOLID WHEN
DRILLING. CRACKS AND EXPANSION SEAMS
REDUCE THE EFFECTIVENESS OF THE WEJ-IT
ANCHOR. NEVER INSTALL THE ANCHOR
UNDER THESE CONDITIONS.
x
NEVER USE AN IMPACT TOOL TO TIGHTEN
THE WEJ-IT ANCHORS. USE A TORQUE
WRENCH ONLY.