INSTALLATION INSTRUCTIONS
11
3. If supply lines are bent, carefully straighten each
one using two hands. Thread supply line nuts on
finger tight, then holding one threaded fitting with
a wrench, tighten nut with another wrench, rotating
one half turn. Do not overtighten. Make
connections to existing hot and cold stop valves.
The hot supply tube is always to the left when
threaded shank is positioned to rear. Turn on
water.
CAUTION: Severe bends of the supply lines may
cause crimping and restricted water flow could result.
1. Place plumber's putty (14) under seat (3).
2. Thread mounting nut (6), washer (5) and bottom gasket (4) onto drain body (7).
Wrap top threaded end of drain body with Teflon tape (16).
3. Position drain body up through drain opening and screw seat onto drain body.
4. Align the drain body so that the pivot rod opening faces the rear of the sink and
tighten the mounting nut snug.
5. Apply Teflon tape to the threaded end of tailpiece (13) and screw into the drain
body. Tighten firmly by hand.
6. Drop in drain plug (1) and install pivot rod in one of the following ways:
(A) VANDALPROOF: Prevents unauthorized removal of drain plug. Place pivot
rod seat (8) into opening of drain body as shown. Place the pivot rod (15) into the
opening and position the pivot rod through the drain plug hole as shown in
illustration (A) above. Slide the pivot nut (9) onto the pivot rod and thread it snugly
onto the drain body, be careful not to overtighten.
(B) EASY REMOVAL: For quick removal of drain plug for cleaning, follow
instructions above except position parts as shown in illustration (B) above.
7. With lift rod (2) in position on the faucet, insert the end into the lift rod strap (10)
and secure with lift rod strap screw (11).
8. Connect the pivot rod (15) to lift rod strap using spring clip (12) as shown
above.
9. Place the drain plug in the full open position, loosen lift rod strap screw and
adjust the lift rod height so that the knob clears the faucet. Tighten the lift rod
strap screw. Installation is now complete.
14
11
10
15
12
1
3
8
9
4
6
7
16
13
5
2
1
15
1
15
(A)
(B)
1
2
3
1
Drain Plug
2
Lift Rod & Knob
3
Seat
4
Bottom Gasket
5
Mounting Washer
6
Mounting Nut
7
Drain Body
8
Pivot Rod Seat
9
Pivot Nut
10
Lift Rod Strap
11
Lift Rod Strap Screw
12
Spring Clip
13
Tailpiece
14
Plumber’s Putty
15
Pivot Rod
16
Teflon Tape
2
14
12
2. From below the deck, assemble the
gasket (12), horseshoe (13) and
mounting nut (14) to the mounting
shank. Tighten the mounting nut (do
not overtighten). Connect the inlet
supplies to the hot and cold water
supply lines. Turn on water.
1. Be sure the mounting surface
is clean and dry.
With the supply lines (11)
connected to the faucet, drop
the faucet supply lines through
the deck.
13
