93
/140
Network And Power Connection
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
•
Remove the sealing plug
: Push one of the three sealing
plugs out of the housing by pushing it from the inside.
•
Prepare MxBus cable
: Strip 5 mm (1/5 in) of insula-
tion from the wire ends of the MxBus cable. Then
push each wire into one of the holes in the single
wire plug (this prevents humidity from entering
the camera).
•
Insert single-wire plug with MxBus cable
: Push the single-
wire plug with the MxBus wires from the rear into the housing
(make sure that the plug is seated properly).
•
Insert MxBus connector
: Push the MxBus connector into
the receptacle on the mainboard (red arrow in figure).
•
Connect MxBus cable
: Use one single-wire connector to
join one wire color of the MxBus cable and repeat for the
other color. Store the connectors within the camera housing
so that they do not obstruct the main board when adjusting
the camera image.
•
Remove the camera dome
: Take the delivered plastic foil
or a cotton cloth, insert the dome into its seat and turn it in
clockwise direction.
•
Attach the outer shell
: Place the outer shell onto the camera
and tighten all four Allen screws using the supplied Allen
wrench. Make sure that the rubber seal is seated properly.
1
2
Содержание D25M
Страница 9: ...9 140 MOBOTIX AG Security Vision Systems Made in Germany www mobotix com sales mobotix com ...
Страница 137: ...137 140 Additional Notes MOBOTIX AG Security Vision Systems Made in Germany www mobotix com sales mobotix com Notes ...
Страница 138: ...138 140 D25M Camera Manual MOBOTIX AG Security Vision Systems Made in Germany www mobotix com sales mobotix com Notes ...
