MLT Inverters Nomad 80, Руководство пользователя

Страница: 7 / 44

1. Introduction
1.1 Warnings and Cautions
A safety instruction (message) includes a hazard alert symbol and a signal word, WARNING or
CAUTION. Each signal word has the following meaning:
HIGH VOLTAGE: This symbol indicates the presence of a high voltage. It calls your
attention to items or operations that could be dangerous to yourself or others
operating this equipment. Read the message and follow the instructions carefully.
WARNING: Indicates a potentially hazardous situation which, if not avoided, can result
in serious injury or death.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, can result
in minor to moderate injury, or serious damage to the product. The situation
described in the CAUTION may, if not avoided, lead to serious results.
GENERAL WARNINGS
DANGER OF ELECTRIC SHOCK. There are no user serviceable parts inside the charge controller. DO NOT attempt
to make repairs or alterations to the unit.
WARNING: This equipment should be installed, adjusted, and serviced by qualified electrical maintenance
personnel familiar with the construction and operation of the equipment and the hazards involved. Failure to
observe this precaution could result in personal injury.
GENERAL CAUTIONS
CAUTION: Always wear personal protective equipment (protective clothing, gloves, and safety boots) while
performing an installation or maintenance, to avoid the danger of injuries.
CAUTION: Proper grounds, disconnecting devices, e.g. bypass boxes and other safety devices and their location
are the responsibility of the user and are not provided by MLT Inverters.
CAUTION: Do not cover the device or store it in a small space - always keep it well ventilated and well away from
flammable gases or powders. Components in the device could potentially cause a small electric spark that could
ignite flammable gas or powders. Flammable gases are created by batteries and can become a hazard in poorly
ventilated spaces.
CAUTION: For indoor use only and MUST be installed in a dry area free from conductive liquids or conductive
debris. If part of the charge controller becomes submerged in water look for a safe way to isolate it at the
distribution board and if possible at the batteries.
PAGE
6
NOMAD USER MANUAL