MLis MLB-S-BGS2-BW, Руководство пользователя

Страница: 33 / 56

MLB-S-BGS2-BW Terminal User Guide 33 Rev 1.3
"dns1" Primary DNS server address (IP address in dotted-four-byte format).
This value determines whether to use the DNS server addresses dynamically
assigned by the network or a specific DNS server address given by the user.
"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile uses
dynamic DNS assignment. Any other address means that the Primary DNS is
manually set.
The default value applies automatically if no other address is set. Note that the
AT^SICS read command only returns a manually configured IP address, while the
value "0.0.0.0" is not indicated at all, no matter whether assumed by default or
explicitly specified.
See also note below.
"dns2" Secondary DNS server address (IP address in dotted-four-byte format).
If "dns1" = "0.0.0.0" this setting will be ignored. Otherwise this value can be used
to manually configure an alternate server for the DNS1.
If "dns1" is not equal "0.0.0.0" and no "dns2" address is given, then
"dns2"="0.0.0.0" will be assumed automatically. The AT^SICS read command only
returns a manually configured IP address, while the value "0.0.0.0" is not indicated
at all, no matter whether assumed by default or explicitly specified.
< conParmValue >
(str)
Parameter value; type and supported content depend on related <conParmTag>.
< conParmValue − conType >
(str)
Supported connection type values in <conParmValue> for <conParmTag> value "conType".
CSD Circuit-switched data call.
GPRS0 GPRS connection.
Settings of GPRS related commands are not used, e.g. AT+CGDCONT. When a
service based on a GPRS connection profile is started after entering AT^SISO
MLB-S-BGS2-BW automatically tries to attach to the GPRS. Yet, the only
exception is AT+CGATT which can be used any time to detach from the GPRS
and thus disconnect the bearer opened with AT^SISO.
none Clears the connection profile.