MLis MLB-S-BGS2-BW, Руководство пользователя

Страница: 43 / 56

MLB-S-BGS2-BW Terminal User Guide 43 Rev 1.3
If "smAuth" = 0 (default): MLB-S-BGS2-BW performs action without SMTP authentication.
If "smAuth" = 1: Authentication procedure with the SMTP server will be performed by means of
supported authentication methods, using values of "user" and "passwd" parameters. If MLB-S-
BGS2-BW and SMTP server are not able to negotiate an authentication mechanism supported by
both parties, the MLB-S-BGS2-BW continues action without authentication.
MLB-S-BGS2-BW supports SMTP authentication.
pCmd POP3 user command to be executed by the POP3 service (numeric).
For supported values of <srvParmValue> refer to <srvParmValue-pCmd>.
pNumber Optional message number argument used by the POP3 commands List ("2"), Retrieve ("3") and
Delete ("4"). For POP3 commands see <srvParmTag> value "pCmd".
Length: 0...
2
31
-1
If no specific value is set in the service profile, the value "0" is assumed by default, i.e. "pNumber"
is disabled.
pLength Maximum message length (string, optional)
Length: 0...
2
31
-1
"pLength" can be used to specify the length of the message(s) to be retrieved from or deleted on
the POP3 server. If no specific value is set in the service profile, the default value "0" is assumed,
which means that there is no limit on the message size.
A warning will be issued inthe following cases:
• If "pNumber" > 0 and a specific message to be retrieved from / deleted on the server is longer
than "pLength".
• If "pNumber" = 0 and all messages to be retrieved from / deleted on the server are longer than
"pLength".
No warning will be issued in the following cases:
• If there are no messages at all on the server.
• If the server has message(s) below and above the "pLength" specified. In this case, the
message(s) within the range of "pLength" can be successfully retrieved or deleted, but the
message(s) above "pLength" remain on the server without any further notification given to the
user.
• Therefore, after retrieving / deleting messages, it is recommended to check the message status
on the server. This can be done by adding a further POP3 service profile using the POP3 user
command List ("2").
pDelFlag Flag to be used with the POP3 user command Retrieve ("3"). Specifies whether or not to delete
retrieved emails on the server (optional).