MKS UniMag 971, Руководство по эксплуатации и установке, Страница: 30 / 44

971 UniMag ™ Operation manual 27
Setpoint setup and configuration
Command Response Explanation
@xxxSP1!2.00E+1;FF
@xxxSP2!2.00E+1;FF
@xxxSP3!2.00E+1;FF @xxxACK2.00E+1;FF Set point 1-3 switch value.
@xxxSH1!5.00E+1;FF
@xxxSH2!5.00E+1;FF
@xxxSH3!5.00E+1;FF @xxxACK5.00E+1;FF Set point 1-3 hysteresis switch value.
@xxxEN1!ON;FF
@xxxEN2!ON;FF
@xxxEN3!ON;FF @xxxACKON;FF Set point 1-3 enable status (ON or OFF)
@xxxSD1!BELOW;FF
@xxxSD2!BELOW;FF
@xxxSD3!BELOW;FF @xxxACKBELOW;FF Set point relay direction (ABOVE or BELOW)
If set to above relay will be energized above setpoint value.
If set to below relay will be energized below setpoint value.
@xxxSPD!ON;FF @xxxACKON;FF Setpoint safety delay (prevent pulse trig of setpoint)
Communication setup
Command Response Explanation
@xxxBR!19200;FF @xxxACK19200;FF Set communication Baud rate (4800, 9600, 19200, 38400,
57600, 115200, 230400)
@xxxAD!123;FF @xxxACK123;FF Set transducer communication address (001 to 253)
@xxxRSD!OFF;FF @xxxACKOFF;FF Turn on or off communication delay between receive and
transmit sequence.
Calibration and adjustment
Command Response Explanation
@xxxU!MBAR;FF @xxxACKMBAR;FF Set pressure unit setup (Torr, mbar, Pascal)
@xxxVAC!;FF @xxxACK;FF Executes MicroPirani zero adjustment
@xxxATM!7.60E+2;FF @xxxACK;FF Executes MicroPirani full scale atmospheric adjustment.
@xxxVAC3!;FF @xxxACK;FF Executes Cold Cathode zero adjustment
@xxxAO1!10;FF @xxxACK10;FF Set analog voltage output 1 calibration.
Information setup
Command Response Explanation
@xxxUT!UNIMAG;FF @xxxACKUNIMAG;FF Set transducer user tag
User Switch
Command Response Explanation
@xxxSW!ON;FF @xxxACKON;FF Enable / disable user switch
xxx
= Transducer communication address (001 to 253. Broadcast addresses: 254, 255)