Miyachi DT-350, Руководство пользователя

Страница: 26 / 59

26 D
ESK
T
OP
S
ERIES
–
AUTOMATIC OPERATION
4.3
POST INSTALLATION ADJUSTMENT INSTRUCTIONS
This section describes the post-installation adjustment of the Desktop system and is only to be
carried out by qualified technicians.
4.3.1
DT-350 and 260 systems
The adjustments of the Bond head are done in accordance with the applicable manual:
69H0082 (80N) or 69H0504 (500N).
The front and rear position adjustment is done before shipment. Miyachi trained persons can
do small adjustments according to the customer’s settings.
The height adjustment is set before shipment. If the customer supplies a product support, the
necessary settings are made and the results recorded. If no product support is provided, the
thermode height is set at approximately 40mm above the base plate.
4.3.1.1
Front to rear adjustments for the slideslide
The next figures describes the mechanical adjustment of the pneumatic front/rear slide with 3
positions (DT-360).
Make sure the system air pressure is set
to on.
Position 1: Inlay position (operator side)
Status:
−
Long cylinder: out
−
Short cylinder: in