5-81
Resetting the origin
5 Maintenance and Inspection
16) Press the [Arrow] key, move the cursor, and
set "1" to the J5 axis and J6 axis. Set [0] to
other axes.
17) Press the [EXE] key , and display Confirmation
screen.
18) Press the [F1] key , and the origin position is
set up.
19) Setting of the origin is completed.
20) Refer to
Page 98, "5.6.5 Recording the origin
in this manual, and record the origin data
on the origin data seal.
This complete the Origin setting by the Mechanical stopper method.
<ORIGIN> MECH COMPLETED
J1( ) J2( ) J3( )
J4( ) J5(
1
) J6(
1
)
J7( ) J8( )
CLOSE
123
<ORIGIN> MECH
J1( ) J2( ) J3( )
J4( ) J5(
1
) J6(
1
)
J7( ) J8( )
CLOSE
123
～
SPACE
<ORIGIN> MECH
CHANGE TO ORIGIN. OK?
No
123
Yes
◇◆◇ Release the brake ◇◆◇
Do cursor movement into the parenthesis of each axis by the arrow key. The brakes can be released only for
the axis for which a "1" is displayed on the screen. If the brakes are not to be released, press the [0] key and
display a "0". If the [F1] key on the teaching pendant or the enabling switch is detached while the brakes are
released, the brakes will be work immediately.
◇◆◇ Select the axis of origin setting ◇◆◇
Do cursor movement into the parenthesis of each axis by the arrow key. The origin is set only for the axis for
which a "1" is displayed on the screen. If the origin is not to be set, press the [0] key and display a "0".
Содержание RV-2F Series
Страница 1: ...Mitsubishi Industrial Robot RV 2F Series INSTRUCTION MANUAL ROBOT ARM SETUP MAINTENANCE BFP A8904 C...
Страница 2: ......
Страница 110: ...Appendix 101 Configuration flag 6Appendix...