Mitsubishi GOT1000 Series, Руководство пользователя

Страница: 132 / 250

11 - 12
11.1 Standard I/F Setting
11.1.8 Installing of communication driver
11.1.8 Installing of communication driver
GT10 is factory-installed with the driver for MELSEC-FX.
An installation of the communication driver is required when connected to a controller other than a MELSEC-FX.
When installing the communication driver, first bring up the OS installation screen on the GOT, and then install
the communication driver from drawing software.
Bringing up the OS installation screen
Refer to the chapter below for detailed information on the OS installation screen of the GOT.
Chapter 17. OS INSTALLATION
About the OS installation screen
The OS can be transferred from GT Designer2 or GT Designer3 without displaying
the OS installation screen depending on the combination of the GOT and the
standard monitor OS.
Refer to the chapter below for how to install the communication driver from drawing software.
GT Designer 2 Version Basic Operation/Data Transfer Manual
GT Designer 3 Version Screen Design Manual (Fundamentals)
Checking method of BootOS, Standard monitor OS version
1. Check the version of BootOS or Standard monitor OS installed in GOT at [OS
information] of the utility.
Refer to the following for details.
Section 14.2 OS Information
2. Check the version of BootOS installed in GOT at product shipment on the rating
plate on GOT rear face.
Model BootOS version Standard monitor OS GT Designer2 GT Designer3
GT1020 BootOS version F or later
Standard monitor OS
[01.08.00]
Version2.77F or later
From the first version
GT1030 BootOS version F or later
GT104
From the first version Version2.90U or later
GT105
From the first version Version2.90U or later
Turn the GOT power
on with the lower right
corner touched.
GRAPHIC OPERATION TERMINAL
MODEL
IN 20.4
SERIAL
MITSUBISHI ELECTRIC CORPORATION
MADE IN JAPAN
JY550D26301A
710001 AA
26.4VDC POWER 2.2W MAX
GT1030-LBD
AA
BootOS Version