16
BEFORE OPERATION
USAGE AND KEEPING OF PAPER SHEET SET
2
BEFORE PRINTING
• Fingerprints or dust on the paper’s surface may degrade print quality and cause paper
jams. Immediately after the paper is replaced, 2-3 images may be printed with a blank
part due to hand’s dust or oil. Refer to Pages 13 - 14.
• When print paper is rapidly transferred from a cool place to a hot place, vapor or dew
will be generated on the paper’s surface causing paper jams or degraded print quality.
Leave the print paper in the room to stabilize its temperature before using it.
• When print paper and ink sheet run out during printing, the printing operation stops and
the error lamp “SHEET/PAPER” lights on the LCD display. Set new ink sheet or print
paper.
• If paper feeding is repeated while installing the print paper, the number of prints per roll
may be limited as specified on page 24.
2
2
2
2
2
AFTER PRINTING
•
When the printed paper is touched by a wet hand, the print may be discolored.
• Fading may occur if the print-face is exposed to organic chemical agents which may
affect print paper (e.g. alcohol, ester, ketone based).
• Fading will be accelerated upon contact with PVC-based materials (e.g. adhesive
tapes, rubber erasers, etc.).
• Avoid storing prints in direct sunlight or places with high humidity.
• Leaving the print paper in contact with PVC-based materials causes color of print
paper to come off and to be stained.
2
2
2
2
2
STORAGE
• Never store print paper in places that are close to heater, hot, or humid.
Keep print paper in the place where:
Temperature : 5
°
C-30
°
C(41
°
F-86
°
F)
Humidity : 20-60%RH
NOTE
If the print paper is installed for a long time, the prints may be rolled after printing.
There is no cause for alarm because the print paper is rolled on the inside of the
printing unit.