Mitsubishi MOTORS Lancer Evolution 2009, Руководство пользователя

Страница: 57 / 362

Number of times
the buzzer sounds
Security alarm settings mode
1 Alarm inactive
2 Alarm active
6. Any of the following operations can be used
to terminate the system settings change mode.
l Releasing the windscreen wiper and wash-
er switch.
l Closing the driver’s door.
l Inserting the key into the ignition switch.
l Placing the lamp switch in any position
other than “OFF”.
l Allowing 30 seconds to pass without mak-
ing any changes to the settings.
l The ignition switch is put into the
“LOCK” (PUSH OFF) position. (vehicles
with the keyless operation system)
NOTE
l If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult your MITSUBISHI
MOTORS Authorized Service Point.
l Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the “active” mode.
Setting the system
E00301700499
Follow the procedure below to set the system to the
system armed mode.
1. Turn the ignition switch to the “LOCK” posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors,
the trunk lid and the bonnet.
3. Press the LOCK switch (A) on the remote
control switch of the keyless entry system or
the keyless operation system in order to lock
all the doors.
Except for vehicles with the keyless operation system
Vehicles with keyless operation system
By locking the vehicle using the keyless en-
try system or the keyless operation system,
the system preparation mode is activated.
The buzzer makes an intermittent beeping
sound and the security indicator (B) in the au-
dio panel blinks for confirmation.
NOTE
l The system preparation mode is not activated
when the doors have been locked using a
method other than the keyless entry system
or the keyless operation function {namely a
key, the inside lock knob or the central door
lock switch (vehicles equipped with the cen-
tral door lock switch)}.
l While the bonnet or trunk lid is open, the se-
curity indicator is illuminated and the system
is not armed. When the bonnet or trunk lid is
closed, the system enters its preparation
mode. About 20 seconds later, the system
switches to its armed mode.
4. After approximately 20 seconds, the buzzer
stops, and when the blinking of the security
indicator starts to slow down, at which point
the system armed mode goes into effect.
The security indicator continues to blink dur-
ing the system operational condition.
Locking and unlocking
1-33
1