Mitsubishi Electric PUMY-P250YBM2-BS, Техническое и сервисное руководство

Страница: 148 / 156

148
TCH091
12-5-3. PAR-SL100A-E
Fig. 1
Fig. 3
Fig. 2
Fig. 4
1. Going to the function select mode
Press the button between of 5 seconds.
(Start this operation from the status of remote controller display turned off.)
[CHECK] is lit and ˝00˝ blinks. (Fig. 1)
Press the button to set the ˝50˝.
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
2. Setting the unit number
Press the button to set unit number
A
. (Fig. 2)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
3. Select a mode
Press the button to set Mode number
B
. (Fig. 3)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
Current setting number: 1=1 beep (1 second)
2=2 beep (1 second each)
3=3 beep (1 second each)
4. Selecting the setting number
Use the button to change the Setting number
C
. (Fig. 4)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
5. To select multiple functions continuously
Repeat select
3
and
4
to change multiple function settings continuously.
6. Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit and
press the button.
Note: Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
A
B
C