60
°
30
°
16
Swing louvre function
(how to read the Swing monitor)
The louvre can be made to swing. Select from the 5 possible settings to suit the purpose.
For directing
air into a
closet.
Swing speed is automatically controlled to send air to all
corners of the room.
Press
¡
Starts swing operation.
¡
The swing monitor is displayed.
This indicates the range of louvre swing.
(The louvre and monitor do not move in
synchronization.)
Stop swing
operation
WIDE
UPWARD
LOW AIR
OUTLET
REAR
Convenient
for drying
carpets or
beds.
Short
beep
The swing operation stops when the power cord
is unplugged.
With each
press of the
button
Objective
Recommended swing setting
Explanations of the swing modes
To stop the
louvre at the
desired angle
To cover the
entire room.
For drying
clothes, etc.
¡
Stop swing operation
¡
WIDE
¡
UPWARD
¡
LOW AIR OUTLET
¡
REAR
The louvre stops in a vertical position. The swing monitor turns
off.
To change the louvre to a desired angle, wait until the
louvre stops, then adjust by hand.
The louvre moves slowly through the
last 30° of the swing, as the time
taken to traverse the rear arc is
shorter than that for the upward arc
when moving at a constant speed.
Depending on the angle of the louvre, some air may blow out of
the low air outlet.
The swing function is not available.
Adjust the angle manually (from three
possible positions).
When using the low air outlet, do not close
the louvre, as it needs to open slightly to
make directional adjustments.
∞
The level of noise emitted from the unit varies according to the angle of the air-flow.
∞
The louvre may stop up to a maximum of 8 seconds to correct its position, after which it will start moving
again.
∞
If the louvre is knocked out of the desired angle, readjust by following the above steps.
Move the louvre
from the sides
Inf
ormation
e_mj_e20txh(01_19)_e33.qx 10/17/03 7:46 PM Page 16
