JEP0-IL9416
31
D - 5 Performing LED lamp test
This option is used to carry out forced illumination of all the LEDs located on the front panel.
Operation
Step Description
Switch Press
Indication
1
The setting mode starts. The
SETTING/CANCEL indicator LED comes
on and the item number blinks.
SETTING/
CANCEL
Once
0
2.
1
1
5
Item No.
Item data
S E T T IN G /
C A N C E L
S E L E C T /
S E T
S E T .E N D /
T R IP
U P
D O W N
IN D ./
IN D I.E N D
R E S E T
2
Mode selection (Setting
Æ
Forced
Operation
Æ
Option)
See the section D – 1 for how to select
mode.
5
0
0
8
Item No.
Item data
3
Select the item number “906” (LED lamp
test).
UP
-
o
n
6
0
9
Item No.
Item data
4
Make sure that the item number “906” is
shown in the box, and press the
SELECT/SET switch. The item data box will
start blinking, instead of the item No. box,
so that data can be changed.
SELECT/SET
Once
6
0
9
Item No.
o
n
Item data
5
Change the item data from “NO” (not test)
to “YES” (test).
UP
Once
6
0
9
Item No.
S
E
Y
Item data
6
Make sure that the desired data is shown in
the item data box, and press the
SELECT/SET switch to program the data.
With the “YES” data, the SET.END/TRIP
indicator LED will blink.
At the same time, the item number box will
start blinking instead of the item data box.
Note that the test will not start only by
programming the data here.
SELECT/SET
Once
S
E
Y
6
0
9
Item No.
Item data
S E T T IN G /
C A N C E L
S E L E C T /
S E T
S E T .E N D /
T R IP
U P
D O W N
IN D ./
IN D I.E N D
R E S E T
