Mitsubishi Electric JT-SB116EH-W-CA, Руководство пользователя

Страница: 7 / 46

—7—
4-2 How to use the hand dryer
Open the switch door of the power controll section.
Turn on the power switch.
3.Close the switch door of the power controll section.
Power controll section
Display
Power
switch
Heater
switch
Air
speed
knob
Power lamp
With the heater switch ON
Check lamp
Heater lamp
Power Check Heater Power Check Heater
Power lamp
With the heater switch OFF
Check lamp
Heater lamp
In case of trouble or error
Power Check Heater
Power lamp
With the power switch OFF
Check lamp
Heater lamp
Power lamp
Check lamp
Heater lamp
Power Check Heater
Check lamp
When a malfunction or error occurs, the check lamp on the right side of the display will
either light up or flash. Turn the power switch off, wait approximately 30 seconds until the
all the lamps in the display go off, and then turn the power back on. If the check lamp is
still on or flashing, turn off the power, shut off the ground-fault circuit interrupter, and
When not using the unit for long periods of time
(With the heater switch “OFF”)
* When the heater switch is turned “ON”, approx. 1100 W of power is
consumed to accumulate heat by operating the heater.
Turn the power switch off.
The unit consumes approximately 2W of power even if unused when the power is on.
With both hands open, insert them
all the way in
The unit will come on automatically.
Pull them out slowly,
letting the air blow the
water off. Pull hands all the way
out.
Repeat until dry
1.
2.
Note:
Power lamp and heater lamp turn on. (Display)
Emblem lamp turns on.
Illumination lamp turns on.
Adjust the Air speed knob to the best point.
When the power switch is turned on, make sure to remove
hands from the hand-drying area. Take sufficient care to
avoid this because it may deteriorate the sensitivity of sensor.
-
+
OFF
ON
O
I
OFF
ON
Power
Air speed
Heater
1 2 3
Check lamp
Power lamp
Display
Emblem
Heater lamp
Introduction
Swicth
door
O
I
refer to "10.Troubleshooting (page19)".