Mitsubishi Electric JT-SB116EH-W-CA, Руководство пользователя

Страница: 27 / 46

—28—
(5) Blower
1
Remove the control circuit board. See (4)
1
~
7
.
2 Remove drain pipe clamping screw.
(one PTT screw, 4 x 16, indicated by O )
6 Remove the blower.
Cautions for assembly
Insert the cord bushing securely to the neck.
3 Remove blower cover clamping screws.
(four PTT screws 4 x 16, indicated by
O )
4 Remove the cord bushing. (indicated by )
5 Remove the relay connector. (indicated by
Q
)
Cautions for assembly
• Set the blower lead wires at the left side of this side.
(See photograph.)
• Replace the packing used at the disassembled section with
new one.
• Take care not to twist the packing when installing it.
(6) Light emitting circuit board
1
Remove the front panel. See (4)
1
.
2 Remove panel support plate (left) clamping screws.
(four PTT screws 4 x 16, indicated by
O
, )
Cautions for assembly
• Start to fix the panel support plate from the screw indicated
by .
• Pass the switch lead wires between the panel support plate
and the side plate.